3D OBJECT DESIGN REVISED PROTOTYYPE

 


When revising my template of my object, I had included tabs so that I could put the pieces together and hide things like tape and glue while doing so. With glue, I used a toothpick to spread the glue as well as get into tight spaces with glue. To hold the pieces together as the glue dried, I used tape to ensure that they would stay together.




For the times I couldn't hide the tape, for example when applying the ears, I made sure to have other pieces cover them up.




finished revised prototype:








Comments

Post a Comment

Popular posts from this blog

Reverse Engineer Project Process 2

Image
 I added more to the sides I created last week! Using shaping tools and Boolean Difference, I decided to add some of the parts needed to click the side together. These bits also act as a place to wedge in a screw.  I also used a Fillet edge for this part, as this is where the screws go into and it is smooth on the actual model.                                          For smaller pieces within the shell, I used Revolve I tried to align things with the parts they were supposed to interlock at the best I could so it would make as much sense with the real object when it clicks together For the speaker, I first made a small radial pattern of circles. I did this with the help of an array on a curve so that I could make each hole very quickly and shift it with rotation on each row. I then selected each circle, extruded it through the side, and used Boolean difference. This is all that I have so far! I still need to get the very small and fine details of it, but that is a task for the me of n
Read more

Reverse Engineer Object Process 1

Image
  Continuing from the last post, I decided to try and model the dog speaker within Rhino. I wanted to try and do the outer casings of the dog speaker.  I started with creating lines to map out the casing, using loft and extruded curves to create them To create the legs of the speaker, I measured the radius and length of the object and created them using the Revolve tool. Once those were done, I attached them to the side casing using a Boolean Union. I also used the shell to give dimension to the casing. And here's the casing! I'd have to duplicate it to create the other side. I want to continue adding more detail to it, especially when it comes to the inner parts, but I wanted to start off with this so that I have a main base to create for the other parts.
Read more

SURFACE DESIGN: LASER CUTTING

Image
 Continuing from the last blog post on Surface Design, we had to make our design into a laser-cut design.  Before sending the file to be laser-cut, I had to change the colours of the design. I had to change the values of each, making them shades of black and white. This would determine how deep each segment is going to be, black being the deepest while white being the least deep. The red outlines determine the parts of the design that will be cleanly cut off. We had to place this design on a 4" x 4" area. Once the file was prepared, I was able to transport it to get it laser-cut. I chose wood for the medium. Once it was cut, I was able to sand off the burns and as well as make some of the segments of the design lighter.
Read more